%PDF- <> %âãÏÓ endobj 2 0 obj <> endobj 3 0 obj <>/ExtGState<>/ProcSet[/PDF/Text/ImageB/ImageC/ImageI] >>/Annots[ 28 0 R 29 0 R] /MediaBox[ 0 0 595.5 842.25] /Contents 4 0 R/Group<>/Tabs/S>> endobj ºaâÚÎΞ-ÌE1ÍØÄ÷{òò2ÿ ÛÖ^ÔÀá TÎ{¦?§®¥kuµùÕ5sLOšuY>endobj 2 0 obj<>endobj 2 0 obj<>endobj 2 0 obj<>endobj 2 0 obj<> endobj 2 0 obj<>endobj 2 0 obj<>es 3 0 R>> endobj 2 0 obj<> ox[ 0.000000 0.000000 609.600000 935.600000]/Fi endobj 3 0 obj<> endobj 7 1 obj<>/ProcSet[/PDF/Text/ImageB/ImageC/ImageI]>>/Subtype/Form>> stream
/* * i2c-gpio interface to platform code * * Copyright (C) 2007 Atmel Corporation * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as * published by the Free Software Foundation. */ #ifndef _LINUX_I2C_GPIO_H #define _LINUX_I2C_GPIO_H /** * struct i2c_gpio_platform_data - Platform-dependent data for i2c-gpio * @udelay: signal toggle delay. SCL frequency is (500 / udelay) kHz * @timeout: clock stretching timeout in jiffies. If the slave keeps * SCL low for longer than this, the transfer will time out. * @sda_is_open_drain: SDA is configured as open drain, i.e. the pin * isn't actively driven high when setting the output value high. * gpio_get_value() must return the actual pin state even if the * pin is configured as an output. * @scl_is_open_drain: SCL is set up as open drain. Same requirements * as for sda_is_open_drain apply. * @scl_is_output_only: SCL output drivers cannot be turned off. */ struct i2c_gpio_platform_data { int udelay; int timeout; unsigned int sda_is_open_drain:1; unsigned int scl_is_open_drain:1; unsigned int scl_is_output_only:1; }; #endif /* _LINUX_I2C_GPIO_H */