ikan Uploader :
Directory : /proc/self/root/usr/src/linux-headers-5.4.0-1103-aws/include/linux/
Upload File : |
| Current File : //proc/self/root/usr/src/linux-headers-5.4.0-1103-aws/include/linux/smc91x.h |
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef __SMC91X_H__
#define __SMC91X_H__
/*
* These bits define which access sizes a platform can support, rather
* than the maximal access size. So, if your platform can do 16-bit
* and 32-bit accesses to the SMC91x device, but not 8-bit, set both
* SMC91X_USE_16BIT and SMC91X_USE_32BIT.
*
* The SMC91x driver requires at least one of SMC91X_USE_8BIT or
* SMC91X_USE_16BIT to be supported - just setting SMC91X_USE_32BIT is
* an invalid configuration.
*/
#define SMC91X_USE_8BIT (1 << 0)
#define SMC91X_USE_16BIT (1 << 1)
#define SMC91X_USE_32BIT (1 << 2)
#define SMC91X_NOWAIT (1 << 3)
/* two bits for IO_SHIFT, let's hope later designs will keep this sane */
#define SMC91X_IO_SHIFT_0 (0 << 4)
#define SMC91X_IO_SHIFT_1 (1 << 4)
#define SMC91X_IO_SHIFT_2 (2 << 4)
#define SMC91X_IO_SHIFT_3 (3 << 4)
#define SMC91X_IO_SHIFT(x) (((x) >> 4) & 0x3)
#define SMC91X_USE_DMA (1 << 6)
#define RPC_LED_100_10 (0x00) /* LED = 100Mbps OR's with 10Mbps link detect */
#define RPC_LED_RES (0x01) /* LED = Reserved */
#define RPC_LED_10 (0x02) /* LED = 10Mbps link detect */
#define RPC_LED_FD (0x03) /* LED = Full Duplex Mode */
#define RPC_LED_TX_RX (0x04) /* LED = TX or RX packet occurred */
#define RPC_LED_100 (0x05) /* LED = 100Mbps link detect */
#define RPC_LED_TX (0x06) /* LED = TX packet occurred */
#define RPC_LED_RX (0x07) /* LED = RX packet occurred */
struct smc91x_platdata {
unsigned long flags;
unsigned char leda;
unsigned char ledb;
bool pxa_u16_align4; /* PXA buggy u16 writes on 4*n+2 addresses */
};
#endif /* __SMC91X_H__ */
Kontol Shell Bypass