ikan Uploader :
Directory : /snap/core/17212/etc/default/
Upload File : |
| Current File : //snap/core/17212/etc/default/ubuntu-fan |
#
# Configuration for Ubuntu fan overlay network
#
# FAN_OVERLAY defines the /8 network that is the overlay network.
# It is supplied in the format "250.0.0.0/8". Note that the /8 specified
# will, if a routable destination, be superseded by the fan overlay.
#
# If this is not set, the fan will not be configured.
#
#FAN_OVERLAY="250.0.0.0/8"
# Use a bridge specifically for the fan overlay. May be set to false
# to use a pre-existing bridge, e.g., one provided by lxc. In that case,
# the bridge must be configured for use with fan.
#
USE_FAN_BRIDGE="true"
# Name of the fan bridge, if USE_FAN_BRIDGE is set to true.
# Note if you change the bridge name you need to
# hange /etc/dnsmasq.d/ubuntu-fan to match.
#
FAN_BRIDGE="fanbr0"
# The network interface to utilize for the fan overlay traffic. If
# not specified here, the interface associated with the default
# route is chosen.
#
#FAN_PRIMARY="eth0"
# FAN_PRIMARY_ADDR contains the IPv4 address on the FAN_PRIMARY
# interface to use for the fan.
#
# If this is not specified, the first IPv4 address assigned to the
# FAN_PRIMARY interface is utilized. FAN_PRIMARY_ADDR is specified
# as an IPv4 address without a network mask specifier.
#
# It is expected that this address will be part of a /16 subnet to
# be utilized for the fan underlay.
#
#FAN_PRIMARY_ADDR="10.2.3.4"
# Name of the tunnel device used for fan traffic
#
FAN_DEV="fan0"
Kontol Shell Bypass